Need directions and/or assembly picture

[Jags87]

Hey guys, i just got this TM SR-16 and Iam trying to convert it back to the full stock. Iam a newbie so iam not a to sure on this maintinance and upradeing kind of stuff. So if someone could gladly help me out that would be great. The stock on it is a tactical CA adjustable stock. I need some where to put the battery so iam going to put the orginal stock back on it. Well ill talk to you all later, you can pm me im me or just drop me a line via email. later

[Ganef]

For any TM M4 the only way to take off the stock is by removing the screw that holds the stock tube to the body of the gun. To do this you must remove the end cap by taking out the set screw on the underside of the stock tube and then the end cap should come off revealing a phillips (+) screw deep down the stock tube. Remove that and the stock tube should come off. There should be a long screw on the full stock and should plug into the place that the tube went and screw into place. Of course this is all suposing that you know how to rewire your gearbox to the rear. To do that you must take the rest of your gun apart. Good luck.

[Jags87]

Ok i have done everything everyone has told me but the tube wont slide off at all, i dont know what the problem is, if some one that is good with these AEG's lives near me maybe you could come over or somthing and fix this for me. well thanks for all the tips guys, ill cya all later, Jags87

[Ganef]

Make sure that you remove the screw deep in the stock tube fully before trying to remove it. It does have long threads and takes quite a few turns to get it off. After the screw is removed there should be nothing else holding the tube on, and if it is stuck try and get a small prying tool in-between the tube and the body or give it a smack or two, just remember that the body is plastic and can damage easily and do not bend like trying to break a branch because you will break off the mounting post and then you will need a new body. PM sent