TM VSR-10 Issues

[Katabatik]

Hey all,

I just finished upgrading my vsr-10 and am having a problem that I cannot figure out...

-Laylax PSS10 170 Spring
-Laylax Prometheus 6.03 mm Tightbore (303 mm for G-Spec version)
-Laylax PSS10 Zero Trigger (includes Orange High Pressure Piston)
-Laylax PSS10 Spring Guide
-Laylax PSS10 Teflon Cylinder
-Laylax PSS10 Air Seal Damper Cylinder Head
- 9 ball- hopup bucking

So I get this thing all together and what is happening is when I load the magazine the first bb loads and fires. Then when I pull the bolt for the 2nd bb to load, the bb will not fire it seems to get stuck under the bucking and below the cylinder head. Any suggestion how to fix this?

Thanks,
Kata

[HimmelChef]

any luck on your issues Kata?  My set up is about the same except im running a 150 atm to see the diff in output vs 170.I do swap out from 150 to 170 and vise versa.  And minus the hop up bucking. No problems yet *knock on wood*.  
------
My guess for your issue, check the hop up maybe its not lined up all the way, happend to me when i didnt, put my hop up back in the 'grove' with the exterior little nub thing. idk if this helps but i could shoot a shot for ya maybe with the cam.