MP9 buffer plate

[xgecko54]

The recoil buffer plate on my kmp9 is loose, which doesn't let the bolt cycle (aka the thing in the back that has the rubber on it)

Is there any good way to hold this thing in place without tightening the screws (meaning you have to remove the entire assembly aka bending plastic, lots of stress D: )? I was thinking locktite or epoxy, but then again if I wanted to remove it that would be an issue.

[WizzerGizzer]

same thing happened to me, as a result my upper receiver decided to snap (funny huh), if you want to put it back in you would need to take the whole gun apart, and if you did, i would suggest tightening that thing as tight as you possibly could.






oh... and tell me how it goes.

[xgecko54]

A new problem is occuring, the bolt won't go back I decided just to give it to someone who knows what they're doing, I will probably catch the gun on fire if I try to mess with that lol. Problem is I don't know any tech people that'll fix it up quick.

[Shdsteel]

Where are you located in the valley? Depending on where you live, there are several techs that should be by you.

[Fung Li]

Unfortunately, mp9s are one of the few gas guns I'm not familiar with

[Exarach]

Unfortunately, mp9s are one of the few gas guns I'm not familiar with

I have an asahi M60, can you help me with that?

[Fung Li]

Unfortunately, mp9s are one of the few gas guns I'm not familiar with

I have an asahi M60, can you help me with that?

I'm really only familiar with handguns and mp7, sorry

[WizzerGizzer]

A new problem is occuring, the bolt won't go back I decided just to give it to someone who knows what they're doing, I will probably catch the gun on fire if I try to mess with that lol. Problem is I don't know any tech people that'll fix it up quick.

dont give it to vangurdle, they have no fucking idea what they're talking about,. Just take it apart carefully, and try not to pull off a kuhn.

[Fung Li]

I don't think he knows what a Kuhn is...

[xgecko54]

A new problem is occuring, the bolt won't go back I decided just to give it to someone who knows what they're doing, I will probably catch the gun on fire if I try to mess with that lol. Problem is I don't know any tech people that'll fix it up quick.

dont give it to vangurdle, they have no fucking idea what they're talking about,. Just take it apart carefully, and try not to pull off a kuhn.

I have the sense I'm better off not knowing what a kuhn is...